Mapping GUI does not allow all configured data to be mapped

Steps to reproduce:

1. Create new Sycon project:  NT100  DPS_NVR

• Select  all 64 bytes In/Out in NT NVR  configuration page
• Set some modules in NT DPS configuration page.
• Map some data in NT mapping page

2. Save project. Close it.

3. Reopen it , change in  NT NVR  configuration In/Out data to default (1024In/Out) using "DEFAULT" button.

4. Check NT mapping page.

Expected results:

All configured signals can be mapped

Actual resutls:

Only 64 NVR  bytes can be mapped